Re-String-Free Re-String with any other repair. Only the cost of strings will apply.
Truss Adjust – Straighten Fingerboard/Correct Relief.
Install Strap Button –Per your requirements.
Machine Head Adjustment – Adjust Tension on Tuning Machines & Lubricate Gears (If Necessary).
Action Adjustment – Acoustic/Electric – Set String Height At Nut & Saddle.
Intonation Adjustment – Acoustic/Electric/Archtop – Set String Length At Nut & Saddle.
Tremolo Adjustment – Adjust Tension – Balance Tremolo Left to Right & Front to Back.
Compound Finish – Compound, Buff & Polish Finish.
Complete Setup – Complete Setup Includes Re-String, Fret Buff, Truss Adjust, Intonation and Action Adjust, Fingerboard Treatment, Machine Head Adjust and Lubrication, Tremolo Adjustment, Replacement of Springs (if necessary), Spray Electronics,
Replace Pickguard – (Stock) Replace & Finish Top Wood (If Necessary).
Replace With Bone & Blank
Replace Compensating Saddle (Bone)
Fill & Re-Cut Saddle Slot
Replace With Bone Blank – 6 string/12 string.
Replace With Brass
Fill & Re-Cut Nut Slots
Install Violin, Viola, Cello nut – Octave nut
Bridge Replacement – as required all Stringed instruments
Custom Bridge – Acoustic / Archtop.
Re-Size/Re-shape Bridge – Shave Down Bridge On Acoustic Guitars To Allow Correct String Tension/Angle And Correct Action That Is Too High (alternative to neck reset on some guitars).
Re-Glue Bridge – Includes Sanding Under Bridge & Adding Wood (If Necessary).
Bridge Cracks – Seal Cracks In Bridge W/ Epoxy/Wood Filler/Or Wood.
Bridge Pad/Plate Replacement – Acoustic Guitars.
Worn Pin Holes/Plate Repair – Re-Route Bridge Pin Holes on Bridge & Bridge Pad.
Fingerboard & Frets
Heat Treatment/Stress Neck – Straighten Neck With No Truss Rod or When Truss Rod Is Too Tight To Move.
Plane Fingerboard – Square Up Fingerboard.
Replace Fingerboard – Remove Old Fingerboard & Replace – With or W/O Binding.
Re-Crown – Re-Round Top of Frets – Buff/Polish & Clean Fingerboard.
Fret Ends – File Fret Overhang.
Complete Fret Job – Level/Mill/Set Radius/Re-Crown & Dress Frets.
Fret Reset/Partial Re-Fret – Priced Per Fret – With or W/O Binding.
Complete Re-Fret – Pull Frets/Install New Frets/Includes Complete Fret Job & Fingerboard Repairs- With or W/O Binding.
All Arch Tops Require Minimum Bench Fee $45
Replace Selector Switch
Run Tailpiece Ground On Solid Body
Install Mini Toggle Or Push/Pull Pot
Install Output Jack
Install Pre-amp (Pre-amp Not Included).
Complete Rewire – Standard Wiring & Custom Wiring.
Hum & Electrostatic Shielding
Spray Electronics – Clean & Lube Noisy Pots.
Transducer Installation – All types and brands-Saddle Type – Microphone (Miniflex) – Soundhole W/ Endpin Jack.
Machine Head Replacement -Replace Tuning Machines, Fill Old Screw Holes & Re-Route Tuning Peg Holes.
Broken Peg Head – With or W/O Finish.
Neck Reset – Correct Angle of Neck – With or W/O Binding.
New Neck – Replace Old Neck With Factory Part.
Flatten Top – With or W/O New Plate – Bridge Removal – Required.
On most instruments, quoted based on severity of damage.